Boat trailer running lights not working?
I have an issue with my boat trailer lights. The brake lights and turn signal lights work but none of the running lights. The bulbs appear to be good so I don’t think that’s the issue. I did find one white wire that isn’t connected to anything on the back of one of the rear lights but can’t figure out where it may go. Also, when I took the lense off of the light where the loose white wire is, water poured out…. Any suggestions?
Enjoy this post? Leave a comment below and add to the discussion and I'll send you a free gift. Thanks!
Tweet This Post 
Plurk This Post 
Buzz This Post 
Delicious 
Digg This Post 
Ping This Post 
Reddit This Post 
Stumble This Post
Related posts:
- How do I add amber side running lights to a four pole flat boat trailer wiring system? I need to add amber running lights to the side...
- Why do both my boat trailer lights blink when I turn on the running lights? Boat trailer lights both blinking when I turn on the...
- I put on a new wiring harness on my boat trailer,turn and brake lights work but no running lights.can you help? I have no tail lights or running lights on my...
- What could be wrong with my car wiring that my blinkers and break lights no longer work on my boat trailer? First I had brake and tail lights. Then the fuse...
- How do I wire a boat trailer with out running lights/? I am rewiring a bout trailer with old wiring still...
This entry was posted on at and is filed under Towing. You can follow any responses to this entry through the RSS 2.0 feed. You can leave a response, or trackback from your own site.
October 10th, 2009 at 6:14 am
White must be the ground. water will short anything out to ground.
Brown is tail , yellow is left, and green is right. and white or black is ground. Are you getting power to the running lights to the connector? Past the connector? Do you have a Good ground?
Your going to have to trace it back with a test light or probe.